Where to put the wifi to get through an entire home

Most households use wireless routers to connect to the network Although it is customary that the host computer do cable, mobility trends and using various devices, such as smartphones and tablets, involve having a good signal level within the house so that every room you can enjoy Internet. There are different devices, such as unidirectional antennas, signal boosters or PLC devices, which can help in extreme cases. However, you can apply logical strategies without spending just wifi networks that deliver the best possible way. The following are what.

From laptops and tablets to game consoles or devices that connect the TV to the Internet, a growing ecosystem of devices requiring the wifi signal to be really useful. Furthermore, the use of technology has moved from the office to the living room, terrace and even the garden: Internet is needed throughout the house and for that, the signal must be distributed as evenly as possible.

Think of the preferred areas, critical

Therefore, before deciding where the router to give wifi signal turns, should address the structure of the house, but not only geometry, but also the distribution of load-bearing walls, decoration and functionality of each room. It is also important to think in what places connected devices will be used more frequently. All these parameters will help decide the status of the router.

Ideally, we would have a square or circular house to locate the emitting source at its center, but this does not always happen. One that gives the street and where the room is, and one that is oriented to the inner courtyard and that is where the office and the bedrooms are located. Often this structure is separated by a corridor along which the bathrooms and kitchen are distributed. This type of structure complicates the optimal distribution of the signal, as it is very possible that if the router in the office, where you have a computer, puts the wifi does not reach the classroom. The same applies if you live in a duplex, if the router is upstairs, the signal will be weak on the bottom and vice versa.

Do not think that because a large bandwidth signal will be better. Maybe in areas where it is weak take a reasonable bandwidth, but it will be unstable.

Search areas of Consensus

In such cases there are technical solutions, such as signal boosters or PLC devices that transmit wifi for electric cables; both alternatives cost money and have limited effectiveness, though they can pull through.

An imaginative alternative is to place the router halfway down the hall, on a small table width if left to spend, or rather in a loft that is built on top of the wall. It’s what we call a zone of consensus.

wifi

This solution requires ingenuity and DIY, it is unsightly and involves throwing a telephone cable along the corridor from the rosette connection, but make sure to have wifi throughout the house. It is important, however, that there is an outlet near and the router is not too close to the kitchen, which is an issuer focus electromagnetic waves interfere with the signal.

In the case of the duplex, the best alternative is to place the router on the floor of the top floor near the staircase connecting the two levels. Yet we must assume that the most remote areas of the stairs on the ground floor have just received signal, while the upper is distributed better.

Overcome obstacles

You can see how the wifi signal is distributed through the house with a simple experiment. You take a tablet or a laptop and access to a web site that measures the speed of the Internet -for tablets and smartphones are different applications that perform this function. Then it moves through the different areas and rooms and runs the measurement. Thus, having a mental map of what the best and worst areas are signal.

This system is also that the signal distribution is not homogeneous. Why? The reason is the obstacles that can find the wifi network to spread. For obstacle physical impairments that hamper the expansion means: thick walls, thick wooden furniture, especially metal, such as appliances; in this sense, the kitchen is a great enemy of wifi. The walls and wood hamper the signal, but the bounce metals by creating distortions and what is known as noise areas where the signal is very unstable.

To overcome these obstacles, the router should be located as high as possible and away from the kitchen. It may seem a little aesthetic apparatus at the top of a shelf, but it is the most suitable place to distribute the signal. In addition to circumvent the furniture, it allows a wider angle of emission tool. It means the portion of emission useful signal to be directed to areas where it is needed.

The signal of wifi is spherical, so if it is located transmitter focus somewhere under, good part will go to the Highlands, where the user is not. From above, the wifi sweeps the lower zones, which are the inhabited, and therefore increases its useful broadcast.

Tags:

Leave a Reply

Your email address will not be published.